Can not change any properties in PR3 Bin VTEC, Rev lim etc..
I am attempting to tune a b18c1 on a PR3 ecu, but when I attempt to make any changes to the properties (Such as VTEC engagment and rev limits) I get this error message:
Run-time error '9':
Subscript out of range
I notice that it only does this with the "Stock Bins" and not others, is there PR3 bin that will allow me to make these changes? If so where would I find it.
Thank you and sorry if this is a dumb noob question, I hit the Wiki and the search with no luck.
|