pgmfi.org

Hacking up Honda's ECU
It is currently Thu Mar 28, 2024 5:19 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sun Dec 20, 2020 5:27 pm 
Offline

Joined: Sun Dec 20, 2020 5:18 pm
Posts: 2
To be brief, I have replaced the ECU once already with a freshly refurbished one from a local tuning shop. The livedata I'm getting off the P28 through the Snake EMU is telling me the ECT reading is 120°F when connected and the engine is room temperature, when the engine is fully warmed up, fans kicking on, it's reading 134°F. I've already replaced the sensor, but when the sensor is disconnected, it's reading 120° when the sensor wires are shorted to each other, it reads 134°. Resistance values are correct on both sensors. I'm still debating on whether or not the Snake EMU is just junk because it was working initially for a few days. Now for the past couple weeks, it's not, even when the signal wire is cutoff from the rest of the harness at the ecu plug, it's still reading 107°F. I'm completely stumped, I don't think it's a harness issue, I'm getting a very consistent 5.00V at the ECT connector.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Bing [Bot] and 12 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group