pgmfi.org

Does ghettodyne use pre-set fuel multipliers? Something along the lines of this:

0 1 1 2 2 3 3 3 3 3 3 3 4 4 4

Now if I changed them to say:

1 1 2 2 2 3 3 3 3 3 4 4 4 4 4

Would ghettodyne still read the file in with the original multipliers?

If you look at the file I attached I changed the multipliers to the latter and when I open the file in ghettodyne it reads the values as if the multipliers were unchanged. but if you open it in the OBD0 Edit prog it has the values I want. Will it run like posted in ghettodyne, or will it use the multipliers I entered (provided I dont save it in ghettodyne)? I really dont want to run lean.

Ben

Attach test...

Bah, the next thread I clicked on answered my question. It appears that GhD assumes stock multipliers. Sorry.

Ben