pgmfi.org

Hacking up Honda's ECU
It is currently Fri Aug 17, 2018 2:23 pm

All times are UTC - 5 hours [ DST ]





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: will this work
PostPosted: Mon Jun 18, 2007 6:42 pm 
i have a p06 i just chipped now i need to program the chip...
its a willem v3.1 single side ath design...amd two different chips
one chip is27c128
2nd is 27c256
which one do i use and how do i set the burner to burn...and place the chip in...its a 30 slot...i have 28 pin chips...and what power does the burner need 12.5 or 5volts help would be greatly appriciated


Top
  
Reply with quote  
 Post subject:
PostPosted: Mon Jun 18, 2007 7:21 pm 
Offline

Joined: Fri Aug 20, 2004 6:33 pm
Posts: 2232
Location: chicago burbs
27c128 is not going to work, you need at least 256k. (last numbers are the size)
27c256 is your best bet. NOTE: it's not electronically eraseable.

I have no idea on the jumper settings for the burner.

why is this in WikiMe?


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB® Forum Software © phpBB Group