pgmfi.org

Hi all, i just try using P30-901 Auto ecu to replace P13-N01 for stock H22A engine, it is because P13 cannot disable knock, and every high load check engine light on with 23 code knock sensor, so i convert P30-901 eg9 auto v-tec ecu to manual and chip it with H22a P30 Jdm bin. But i got code 16, why this happen?

1.My injector lude that have resistor box, it is 330cc?
2.why i got code 16, if there any different b16 and h22a injector wiring?

Code 16 Fuel Injector
Code 23 Knock sensor

disable injector test circuit and knock sensor.

that ECU does not have the injector test circuit, so the test for CEL 16 will always fail.
disable it like inspector01 said.

knock sensor, disable it if you don't want it. (it's also possible that your knock sensor or wiring is bad)

Great!! thank inspector01 + relic1, i just disable injector test circuit and knock sensor, the check light gone.. what actually injectro test circuit for?

i just picked one of these up and it looks like it was already chipped. how do i check if its converted to manual. i hace ic 14 13 15 and 16

RP17 & 18.