pgmfi.org

Hacking up Honda's ECU
It is currently Fri Mar 29, 2024 12:52 am

All times are UTC - 5 hours [ DST ]




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 4 posts ] 
Author Message
PostPosted: Wed May 24, 2006 10:25 pm 
Can not change any properties in PR3 Bin VTEC, Rev lim etc..


I am attempting to tune a b18c1 on a PR3 ecu, but when I attempt to make any changes to the properties (Such as VTEC engagment and rev limits) I get this error message:

Run-time error '9':
Subscript out of range

I notice that it only does this with the "Stock Bins" and not others, is there PR3 bin that will allow me to make these changes? If so where would I find it.

Thank you and sorry if this is a dumb noob question, I hit the Wiki and the search with no luck.


Top
  
Reply with quote  
 Post subject:
PostPosted: Wed May 24, 2006 10:41 pm 
BTW I am using Turbo EDIT 2.5.2


Top
  
Reply with quote  
 Post subject:
PostPosted: Thu May 25, 2006 8:48 pm 
check bre it for obd 0 vtec ecu
(ben rom editor)


Top
  
Reply with quote  
 Post subject:
PostPosted: Fri May 26, 2006 1:37 am 
1st off thanks to Chris at Xenocron fpr some helpful insight and tech suport and 2ndly.......

BRE is the SH!T!!!!!

Thank you Ben, I don't know who you are, but a huge thank you!!! your rom editor is awsome!!!!


Top
  
Reply with quote  
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group