pgmfi.org

Hacking up Honda's ECU
It is currently Fri Mar 29, 2024 2:16 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Tue Jul 03, 2007 3:22 pm 
I hope this is in the right section,

I'm looking for information on the calculations for getting the map sensor voltage to a pressure value...ie psi etc

Thanks


Top
  
Reply with quote  
 Post subject:
PostPosted: Wed Jul 04, 2007 10:08 pm 
Offline

Joined: Tue Jul 27, 2004 3:01 am
Posts: 2945
Location: Tampa bay, Florida
Get to WIKI..

it has a chart for MAP to mbar..
from there you can get the conversions from math.com conversion calculators to adjust to other pressure systems.


Top
 Profile  
Reply with quote  
PostPosted: Sat May 15, 2010 7:23 am 
Offline

Joined: Sat May 15, 2010 7:01 am
Posts: 2
MAP sensors are used in the electronic control system to covert a voltage to pressure at a absolute level.Basically it calculates the air density and identifies the mass flow rate.Air temperature and rpm speed is also useful in this task.


Last edited by johnsmith23687 on Tue Apr 26, 2011 7:34 am, edited 1 time in total.

Top
 Profile  
Reply with quote  
PostPosted: Mon Sep 27, 2010 6:27 am 
Offline

Joined: Sun Sep 26, 2010 10:55 pm
Posts: 4
You can get more information from Wikipedia.com, it stores a very vast collection about Map sensors. In every electronic control system mostly used system is a MAP sensors. It helpful to convert a voltage to pressure at a middle or high absolute level.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group