pgmfi.org

Hacking up Honda's ECU
It is currently Thu Apr 18, 2024 11:13 pm

View unanswered posts | View active topics


Board index » Assistance - ASK QUESTIONS HERE!!! » General Hardware Assistance

All times are UTC - 5 hours [ DST ]



Post new topic This topic is locked, you cannot edit posts or make further replies.  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
'92 HatchGuy
PostPosted: Wed Apr 12, 2006 4:59 pm 
Offline

Joined: Wed Mar 08, 2006 1:53 am
Posts: 17
i have already socketed and chipped my ecu, but there is not enough info on converting P29 ecu to manual...
i've read that for jdm ecu's u need to remove R52.. i already did that.
then they say to remove RP17 and lower RP18 from 2.4kohms to 1.4kohms
but there is no RP18 in this ecu.
what should i do??? should i go ahead and remove RP17 and add a resistor to RP18 spot?
i'd like to hear what others have done with this type of ecu.
Top
 Profile  
 
pacman
 Post subject:
PostPosted: Wed Apr 12, 2006 5:34 pm 
Offline

Joined: Thu Jun 09, 2005 3:53 pm
Posts: 750
Location: Bonny Scotland
To convert a JDM ecu from auto to manual, you only have to change RP18 to a 1.4 ohm SMT resistor.

Why did you remove R52?

http://www.pgmfi.org/twiki/bin/view/Library/OBD1CivicIntegraAutoManual
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic This topic is locked, you cannot edit posts or make further replies.  Page 1 of 1
  [ 2 posts ] 

Board index » Assistance - ASK QUESTIONS HERE!!! » General Hardware Assistance

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 23 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group